Home › Forums › General Discussion Forum › Reamer and bushings
- This topic is empty.
-
AuthorPosts
-
February 5, 2021 at 5:36 am #50227
Hello everyone,
I’m looking the buy a reamer and bushings but I’m not sure what to get. There are so many sizes, what is the best sizes to start with?February 5, 2021 at 7:59 pm #65275Anonymous
Hello Clock King!
That’s a really good question. Fortunately it’s been covered in great detail
Up here over the years. I’ll post some links to some worth reading past discussions
that might help. The first link is a discussion that I was involved in. I posted some
links in a post that will also take you to some good pages. Hope I put the links in correctly.
https://clockrepairtips.com/forum/viewtopic.php?f=2&t=2284&p=16971&hilit=Bushings#p16971
https://clockrepairtips.com/forum/viewtopic.php?f=2&t=2239&p=16822&hilit=Bushing+sizes#p16822
https://clockrepairtips.com/forum/viewtopic.php?f=2&t=2303&hilit=Bushing+sizes
https://clockrepairtips.com/forum/viewtopic.php?f=2&t=2303&p=17031&hilit=Bushings#p17031Let us know if this is what you were asking about Clock King.
DanFebruary 5, 2021 at 8:35 pm #65276Thank you so much!
March 5, 2021 at 3:03 pm #65277Hi again everyone,
I bought a hand reamer and pivot gauge, but now I’m not sure of the best way to measure the plate height. What is best way to measure the height to follow the pivot gauge? I bought a micrometer but I’m too stupid to read it
March 6, 2021 at 7:05 am #65278Get a digital micrometer, online or at Harbor Freight store. Not expensive and easy to read.
March 7, 2021 at 5:04 pm #65279March 9, 2021 at 1:32 pm #65280It’ll work just fine for what you need.
March 9, 2021 at 4:59 pm #65281Awesome!
-
AuthorPosts
- You must be logged in to reply to this topic.