Punch/Stump for large Illinois roller

Home Forums General Discussion Forum Punch/Stump for large Illinois roller

  • This topic is empty.
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #49603
    sstakoff
    Participant
    • Topics Started: 13
    • Total Posts: 42

    Hi… I am attempting to replace the roller table on a double roller Illinois 16s grade 707 model 9.
    The roller shoulder on the staff is quite large – 1.1mm. I am having difficulty finding a roller punch or stump
    large enough to press the roller back on the stump. The only stumps I have with clearance for a roller jewel
    are much smaller. I have a Favorite staking set. I was looking on google and ebay to see if there is something
    large enough to help me set this roller. Any advice??

    Stu

    #62858
    tmac1956
    Participant
    • Topics Started: 171
    • Total Posts: 1259

    Stu:

    I’m using a K & D Inverto staking set which has the added benefit of allowing one to use a punch as a stump. Does yours allow for this? If not, then you should be able to turn one on your lathe out of tool steel and then harden it.

    Thanks,
    Tom

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.
sstakoffPunch/Stump for large Illinois roller