Home Forums Hints, Tips and Tricks Maker centre cam lifting devise.

  • This topic is empty.
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #50172
    john baker
    Participant

      I was watching Bob’s hermle video on dimantling the centre cam. The final step in separating the two plates.
      He used two lifting levers, which I’d not seen before, or did I have them. Naturally, and as I am a long way away
      In Australia, I needed to have these quickly. What could be adapted. Of course, 6 inch nails. A bit brutal I hear you say.
      However with some bending into shape with hammer and large vice(that’s the brutal part), half the job is done.
      Next comes the subtle shaping and polishing with linisher, grinding wheel and sandpaper.
      Job done.

      John from Australia.

      #65138
      Anonymous

        Thanks John,
        I’ve used old high carbon files, sewing needles and other old tools to make different tools and parts but never tried nails. Good tip!

        Dan

      Viewing 2 posts - 1 through 2 (of 2 total)
      • You must be logged in to reply to this topic.