Home › Forums › General Discussion Forum › looking for Lathe video on course
- This topic is empty.
-
AuthorPosts
-
July 9, 2014 at 11:34 am #49122
Hi,
I was wondering if anyone had seen where to find the video of where Bob talks about the face plate on the lathe and other tools? A preview
of it shows up at the end of all the other lathe videos but I can not find it on the watch and clock videos. Anyone know where it is?
thanks!July 10, 2014 at 7:39 am #58475Hi Nic,
I think those shots were from the video that I was working on and haven’t finished yet.
No idea when I’ll be getting back to working on it.
Adios for now,
BobJuly 10, 2014 at 12:15 pm #58476Ah, well I hope you do. I have been wanting to see someone demonstrate the face plate, making dials, movement plates, etc. Please make it!!
July 10, 2014 at 5:39 pm #58477Nic,
Check out the Steffan Pahlow videos on Youtube; especially the MAKING A GLASUTTE BALANCE STAFF video. He uses a variety of lathe accessories to make a balance staff for a rare pocket watch. There are other videos on Youtube that show the making of dials, watch faces, pilar plates and so on. There are also videos by PERPLXR and the University of Oklahoma Watch School showing parts being made fixtured in faceplates.
davidJuly 11, 2014 at 2:20 pm #58478Thanks David, I will for sure look into those.
-
AuthorPosts
- You must be logged in to reply to this topic.