Invicta Crystals

Home Forums General Discussion Forum Invicta Crystals

  • This topic is empty.
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #48507
    randy
    Participant
    • Topics Started: 39
    • Total Posts: 594

    I just got handed an Invicta Pro diver mod 0070 with a smashed crystal.

    Does anyone know where I can source and original part,..or do I just measure it out, and order one the same size from Borel ?

    I’ve seen in the forums where the bezel should pop off with enough pressure from a bench knife.
    I’m assuming that there’s a pretty beefy gasket under this one.

    Thanks
    Randy

    #53000
    arutha
    Participant
    • Topics Started: 85
    • Total Posts: 1536

    Try here for a new crystal http://www.invictawatch.com/support_files/service_center/ServiceCenter.htm
    If you cant get the correct one then just go by size. As for getting the old crystals out, sometimes it helps to warm the bezel up, I am not talking about soldering heat hot, just very warm, it expands the metal and makes it just a touch easier to pop out the old crystal.
    Nice watch :)

    #53001
    randy
    Participant
    • Topics Started: 39
    • Total Posts: 594

    Thanks for the source, and the instruction.

    I’ll keep the soldering iron in my lower bench drawer.. :D
    Hot water or a hair dryer should suffice !

    Regards,

    Randy

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.
randyInvicta Crystals