Hemle movements

Home › Forums › General Discussion Forum › Hemle movements

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • January 30, 2022 at 12:14 pm #66064
    HowardDeHart
    Participant

      I am on my third Hermle movement and I always have trouble with the chime side getting started or running too slow. Is there a common issue with this that I am not aware of? The hammers, the chime train, all run freely when not connected to the other. The movement has been cleaned and I only saw one bushing that I felt needed replacement. And the springs seem to be fine. Any help is appreciated.

      Thanks,

      Howard

       

       

       

       

       

      February 5, 2022 at 11:57 am #66102
      DennisGuessford
      Participant

        I would really like to hear the answer you get on the power issue because I’ve had the exact same issue.

        March 29, 2023 at 7:48 am #68606
        RolandGosselin
        Participant

          Hi, I have a hermle 1151 but I want to calculate the weight of the of the weight and shells, were can I fund the proper anwser.

          Thank you.

           

          December 31, 2023 at 10:36 am #69951
          Chuck Solomon
          Participant

            From the Hermle Service manual:

            1151 Chain lyre ped <165 mm—Time train4.7 lbs/Striking train4.7 lbs/Chiming train7.3 lbs

            1151 Sec hand and/or lyre >165mm—7.3/4.7/7.3 respectively

            Hope this is helpful!

          • Author
            Posts
          Viewing 4 posts - 1 through 4 (of 4 total)
          • You must be logged in to reply to this topic.