Getting Started

Home › Forums › General Discussion Forum › Getting Started

  • This topic is empty.
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • February 14, 2017 at 2:36 pm #49901
    dlgraley
    Participant

      Greetings folks. I am just getting started, and think I have acquired most of the books and hand tools that I’ll need at this point(I love buying tools). I have a line on a used lathe and staking set that I should have soon. My interest at this point is the 18th century verge fusee pocket watch. I acquired one that sort of works, but I have to occasionally shake it a bit to get it ticking again. I’m going to take it apart, examine, clean, and see if I can figure out what the problem is. I’m looking forward to this forum.

      February 16, 2017 at 7:09 am #64272
      willofiam
      Moderator

        Welcome, sounds like your having fun and diving right in….when you get your lathe set up we would like to see it, if you have not noticed there is a section on this forum called member shop pics, you can start your own thread featuring your workspace. I think we all love buying tools too AND enjoy seeing what others have come up with. William

        February 16, 2017 at 4:17 pm #64273
        dlgraley
        Participant

          I certainly will William. I also have a Jacot tool enroute. Thanks for the welcome. Dave

        • Author
          Posts
        Viewing 3 posts - 1 through 3 (of 3 total)
        • You must be logged in to reply to this topic.