Cross slide for 8mm lathe

Home › Forums › General Discussion Forum › Cross slide for 8mm lathe

  • This topic is empty.
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • October 24, 2016 at 2:10 pm #49871
    its time
    Participant

      I am looking to build my own cross slide for my 8mm Wolf Jahn, what I need is plans or some good pictures of one broke down. Drawings would be best. I have a 10 inch lathe and a milling machine just wait to turn them on.
      Any help, thanks
      Nelson

      October 27, 2016 at 10:22 am #64113
      arutha
      Participant

        Are you looking to build an identical copy of an 8mm cross slide? Is it a D bed or a WW type?
        Paul.

        November 9, 2016 at 6:49 pm #64114
        its time
        Participant

          Paul
          I am sorry I have been busy and well sometimes it take too much of my time.
          The lathe is a WW, and yes I would like to make it as close as possible, or at least putting it on and off the lathe. I guess that is what hit my fancy. Using a graver is very nice but sometimes you need a little bit of precision. Again thanks for the reply.
          Cheers
          Nelson

        • Author
          Posts
        Viewing 3 posts - 1 through 3 (of 3 total)
        • You must be logged in to reply to this topic.