collets

[clockman1509]

Good evening all, I suppose this question is for Bob but maybe other forum users will have the answer. Bob I have been watching your video on lathes and you mentioned that you were looking at a chart which gave the measurements for collets. Is this readily available through a supplier? It would to be able to have this reference guide.
thanks
Alan

[Bob Tascione]

Hi Alan,
It’s been a few years since I watched those videos and I remember mentioning something about a chart but can’t remember where it was in the video.
Might have been referencing a drill bit fraction to decimal chart or ‘metric to inch chart’. If that’s the case you can put ‘fraction to decimal chart’ or ‘metric to inch chart’ in google search and you should be able to find one that can be downloaded and printed. If not then supply houses like Enco ect. will have wall charts that can be purchased.

Hope that helps Alan,
Bob

[clockman1509]

Thanks Bob, that’s a great help I will let you know the results.
All the best
Alan

[Author]

Posts