Home Forums General Discussion Forum adjusting raising wire and reshaping

Viewing 1 post (of 1 total)
  • Author
  • #67833

      Hi, My name is Eddy I have just joined the clock repair course. I have a problem with a cuckoo clock that I picked up in an old shearing shed. It is almost identical to a Herbert Haller countwheel clock. I think I have fixed everything except I cannot figure out the shape of the raising wire. It has been bend all sorts of ways . Would somebody have a picture or drawing of what the shape would look like, where the warning pin should hit the wire and any other information to make this working again?

      I have spend many days but not getting anywhere. Your help will be very much appreciated. Regards Eddy

    Viewing 1 post (of 1 total)
    • You must be logged in to reply to this topic.