Home Forums General Discussion Forum 30 Day torsion

  • This topic is empty.
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #50201
    torsion
    Participant

      Hi all hope everyone staying safe
      I am hoping someone can help me as I have a 30 torsion clock ( I know it’s not a anniversary clock) but it’s same principle hence in this forum.
      Anyway I have stripped and cleaned it and I runs fine, but when it is fully wound it gains 30 minutes a day but when it gets to about 2 1/2 to 3 weeks it looses 15 to 20 minutes a day .
      Anyone have any suggestions?

      #65212
      Anonymous

        Hi Dell
        I have had that problem before with the escape an escape wheel tooth skipping past the pallets when fully wound and later settling in when some of the power from the spring has been dissipated. If you only wind the spring up about half way and start it does it still run fast at first?

        Phil

        #65213
        torsion
        Participant

          Hi Phil
          I haven’t tried that will give it a go and see what happens.
          Dell

        Viewing 3 posts - 1 through 3 (of 3 total)
        • You must be logged in to reply to this topic.