Reply To: Machining question…

[demewill]

Nice modification to create a new tool. In my book,there is really nothing that compares to using a tool that you have made for yourself.

I have a suggestion for alternate construction that will allow someone without a mill to make this tool as well. With a hack saw, cut the narrow diameter section of the clamp piece in or near the middle. Make a small sleeve or collar with a set screw near each end of the sleeve. Reassemble turning the slotted end of the original piece 90 degrees and tighten the set screws. If this is a “common” diameter, it may be possible to purchase the sleeve.

Dan