Home Forums General Discussion Forum Removing the movement from case in an Arnex Watch Reply To: Removing the movement from case in an Arnex Watch

#52395
Bob Tascione
Moderator

    Welcome to the forum Renee’
    Your movement has the Parrenin logo but it looks different than other Parrenins I’ve seen. I’m not familiar with that movement but it appears to be of good quality. If you look at where the stem enters the movement you’ll see a small screw sitting just above a larger plate screw. Try backing that smaller screw out a couple of turns while gently pulling out on the stem to see if that releases it. You may need to turn the screw more than a couple of turns but stop turning it as soon as it releases the stem. From what I can tell in your pic that screw head looks larger than most setting lever screws but not sure as I can’t tell what size your watch is from the pic.
    Hope this helps Renee’
    Enjoy,
    Bob