Home › Forums › General Discussion Forum › End Mills › Reply To: End Mills
April 8, 2014 at 8:14 am
#57191
@Daryn wrote:
a lot of four fluters don’t cut in the centre
Thats exactly one thing I learned on that project I just did, a 4 flute straight down onto the piece left a pip in the center, I didnt realize this until I tried to rotate the rotary table 🙄 and it wouldnt as it was stuck over that pip. lighter cuts helped get by that but a 2 flute would have been better for what I was doing. possibly to plunge and move the piece at the same time would also work. William