Home › Forums › General Discussion Forum › Watch cleaning question…
- This topic is empty.
-
AuthorPosts
-
February 23, 2013 at 1:50 pm #48501
All:
Is naptha detrimental to the shellac used to cement-in jewels? I just thought I would ask before I go out on a limb, only to fall off of it.
Thanks,
tmacFebruary 23, 2013 at 4:32 pm #52969Hi Tmac,
Naptha is safe for shellac. Denatured alcohol works as a solvent with shellac though. It’s even used as a shellac thinner.Enjoy,
BobFebruary 23, 2013 at 4:57 pm #52970@Bob Tascione wrote:
Hi Tmac,
Naptha is safe for shellac. Denatured alcohol works as a solvent with shellac though. It’s even used as a shellac thinner.Enjoy,
BobBob:
Thanks for that information. Using the seven jar method listed in your PDF’s, should I keep the balance and pallet fork out of the denatured alchohol and just use one-dip for those? I am assuming that all other parts are ok in the alchohol…Thanks!
tmacFebruary 23, 2013 at 5:07 pm #52971Hi Ttmac,
Yes that would be best. A quick dip in the alcohol usually isn’t a problem but no reason to tempt fate. If you’re going to use naptha as a cleaner then alcohol rinse won’t really be necessary.Bob
February 23, 2013 at 5:12 pm #52972@Bob Tascione wrote:
Hi Ttmac,
Yes that would be best. A quick dip in the alcohol usually isn’t a problem but no reason to tempt fate. If you’re going to use naptha as a cleaner then alcohol rinse won’t really be necessary.Bob
Thanks!
tmacFebruary 24, 2013 at 8:53 am #52973Tmac,
I use a small inexpensive ultrasonic cleaner that I bought from Harbor Freight a few years ago. I tested different solutions such as detergent and water, windex you name it and finally setteled on straight Naptha. I purchase the Naptha from Home Depot by the gallon. When the cleaner has run through its cycle I pull the parts out and place them on a paper towel to air dry. Although I have not noticed any oily residue on the parts I dip the balance assemblies and hairsprings in laquer thinner just to make sure. I do not put the laquer thinner in the ultrasonic cleaner because I do not want to push my luck.
I posted the answer to your time standard question as a new thread (Horology 101) because I thought it might be of more general interest to watch students. Boy was I wrong. The English Beer thread outdrew the number of hits 2 to 1. This shows that watch repair students are twice as interested in beer than horology.
davidMarch 4, 2013 at 7:46 pm #52974All:
When doing manual cleaning, would stringing parts together using aluminum wire cause any problems such as reacting with some of the metals used in the movement?
Thanks,
tmac -
AuthorPosts
- You must be logged in to reply to this topic.