Reply To: Re-Pivoting

Home › Forums › General Discussion Forum › Re-Pivoting › Reply To: Re-Pivoting

April 5, 2014 at 5:06 pm #57131
Bob Tascione
Moderator

    Hi Chris,
    Might be easier to make a new holder that will accept the normal shank size of the drills you have.
    As for the pulley…I would have to ask the same questions that Daryn asked. Is the end pressed on or does something unscrew? If or somehow pull apart? If not then could the pulley have been split or made up of two pieces?
    Enjoy,
    Bob