- Topics Started: 1
- Total Posts: 13
Hi Chaplin, I don’t think this has been mentioned but with the balance assembly out and your pallet fork and bridge in place put a few winds on the mainspring. Now check the pallet fork as it is resting on one banking pin by gently pushing the fork towards the other what you are looking to see if it snap over to the other banking pin. Also you can try slightly pushing the fork off the one it is resting on and see if it snaps back to that banking pin. If this all this happens your problem most likely is in the balance assembly which can be a host of reasons causing your problem. The first place I would look would be to see if the hairspring is level and not touching the balance bridge. Good luck, Steadypin.