kienzle out of tune

Home › Forums › General Discussion Forum › kienzle out of tune

  • This topic is empty.
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • October 11, 2016 at 4:46 am #49864
    james burrows
    Participant

      Hi I have just recently acquired a Kienzle mantel clock which was in a bit of a sorry state I’ve stripped the woodwork down and re-varnished, I got the clock working great and it chimes on the hour ok but the musical chimes start with the 2 gongs that should be at the end starting at the beginning leaving the end of the tune 2 gongs short with the hammers in mid air. James

      October 22, 2016 at 11:16 pm #64095
      arutha
      Participant

        Hi James,
        only guessing as you dont show a picture of the movement but as you look at the back of the clock, if it has a large wheel at the top on the left of the backplate it should have a screw in it. Loosen the screw and turn it until the chimes are starting in the correct place. It can take a few goes to get right :)
        Paul.

        October 24, 2016 at 6:11 am #64096
        bernie weishapl
        Participant

          I agree with Paul. I always take the clock around till it should have chimed the 15 min. Then I take the wheel in the back and turn it till the hammers go 1, 2, 3, and 4. Once there it should chime the rest just fine. Now it will chime that 1, 2, 3, and 4 sequence twice. Once on the 15 minutes and again at the 3/4 hour. So it may take a time or two to get it correct. A picture would help us to see what you have.

        • Author
          Posts
        Viewing 3 posts - 1 through 3 (of 3 total)
        • You must be logged in to reply to this topic.