Home Forums General Discussion Forum incabloc setting Reply To: incabloc setting

#57499
randy
Participant

    Sounds like you two have this all figured out..and Jan, I’ve read where many folks prefer to use the Seitz tool if you have the correct pushers,.but I’m sure that’s not the only way.
    The K&D setup should be fine as well
    I’m thinking that you are going to have to remove the cap jewel, so that you can start to insert the assembly and try-fit the balance until you think you have the correct depth…unless you know the micrometer value already as Tom was saying…

    Just my two cents,..and best of luck !

    Randy