Reply To: Machining question…

Home Forums General Discussion Forum Machining question… Reply To: Machining question…

#57320
willofiam
Moderator
  • Topics Started: 75
  • Total Posts: 1437

Hey Tom, what about putting a snug fitting rod thru the hole you already have and let the rod extend out enough to use as a “platform” to set on top of the vise or whatever and clamp, find center or apex from there and it should be 90 degrees from the other hole, hope that makes sense, I can see how it would work but may not be explaining it right. William

willofiamReply To: Machining question…