Reply To: End Mills

Home Forums General Discussion Forum End Mills Reply To: End Mills

#57191
willofiam
Moderator
  • Topics Started: 75
  • Total Posts: 1437

@Daryn wrote:

a lot of four fluters don’t cut in the centre

Thats exactly one thing I learned on that project I just did, a 4 flute straight down onto the piece left a pip in the center, I didnt realize this until I tried to rotate the rotary table 🙄 and it wouldnt as it was stuck over that pip. lighter cuts helped get by that but a 2 flute would have been better for what I was doing. possibly to plunge and move the piece at the same time would also work. William

willofiamReply To: End Mills