Reply To: Making a New Pin Wheel

Home Forums General Discussion Forum Making a New Pin Wheel Reply To: Making a New Pin Wheel

#56974
daryn
Participant
  • Topics Started: 2
  • Total Posts: 97

Someone decided to repair this English 8day longcase pin wheel by brazing it back together,unfortunately this softens the brass and that’s really not very good for wheel teeth , also they neglected to remove the flux so over time it’s corroded away , here’s a couple of pics of the set up I use for wheel cutting, the teeth and pin holes are all cut in one mounting so everything stays dead true, the lathes been modified quite a bit . . . Any questions welcome :-)

darynReply To: Making a New Pin Wheel