- Topics Started: 75
- Total Posts: 1437
Hey chaplin37, Some good advice already, an easier way to check for binding is like you already did, by checking the train without the balance in, also the lever and balance can be checked without shimming the balance cock, just check for endshake when it is all together, should have a bit of endshake through out the train and escapement.
Have you checked the lock and drop of the escapement at each tooth? how do the banking pins look? are they straight and adjusted with a perceptible amount of run to banking? After all that I think adjusting for beat. That would be my process.
I cant remember right now if Bob shows how to adjust these areas in the videos, I will have to check. getting old William