Home Forums General Discussion Forum Seth Thomas chime clock Reply To: Seth Thomas chime clock

#55927
mclark3617
Participant

    So far it looks like i need one bushing, i used a set of pin guages to measure all the holes in the two plates, the one that need a bushing measures abut .072 thats 1.83mm. The pivot measures .07 or 1.78mm. The bushing chart says i need a bushing with a 1.9mm hole, thats bigger than the original hole. The hole that need bushed is slotted thats how i can get the .072 dia and its the same dia in both plates and only one hole need bushing. Its the wheel right next to the gong mainspring.