Home Forums General Discussion Forum IT ARRIVED Reply To: IT ARRIVED

#55852
willofiam
Moderator

    David, thats a great idea, if I am understanding correctly you would start the cut of the groove at your maximum size, taper the block at whatever determined taper and length, starting at the outer edge with the full depth? by just laying the rod in the groove and spinning? as you file it, it will just fall into the groove with the desired size. FANTASTIC. I wonder if you could even use a stone, emery on the table or a fine grit sandpaper on a orbital sander? When can I come over and learn all the tricks??? :) William