Home › Forums › General Discussion Forum › KD model 600 staking tool problem › Reply To: KD model 600 staking tool problem
February 18, 2014 at 8:06 pm
#55833
Glad you were able to resolve this.
I don’t have that model, but I would think they would be similar to other K&D’s.
I was about to take my inverto apart to look.
Could it just be wear ?
I’m thinking that the previous owner overtightened the nut too many times…you don’t need a lot of force to hold the table in place.
Anyhow…sounds like it’s working…which is a good thing !
Randy