Reply To: T-nuts…

Home Forums General Discussion Forum T-nuts… Reply To: T-nuts…

#55616
david pierce
Participant
  • Topics Started: 90
  • Total Posts: 1360

Tom,
Yes, that is what the adjustment screws are for. Make sure that you do not get them tighter than they need to be in order to tune out the wobble. If they are too tight it will wear out the leadscrew and the dovetails. I think now you can appreciate the advantage that a heavy cast steel machine has over lighter machines. The heavy machine can be pushed a little harder and handle more difficult to machine materials such as steel. As you do this more and more this will start to make even more sense.
david

david pierceReply To: T-nuts…