Reply To: JEWELING CHUCKS

Home Forums General Discussion Forum JEWELING CHUCKS Reply To: JEWELING CHUCKS

#55603
david pierce
Participant
  • Topics Started: 90
  • Total Posts: 1360

Tom,
The boreing head would apply to boreing a hole through a plate. For a round shaft the piece would be turned in a lathe and a boreing bar would be mounted to the cross slide. For your HF mill I would not go larger than a 2 inch boreing head. Smaller is better in this case because you can run the smaller heads faster. Check with MSC and ENCO and see what they have to offer.
david

david pierceReply To: JEWELING CHUCKS