Reply To: Motor Rebuild

Home Forums General Discussion Forum Motor Rebuild Reply To: Motor Rebuild

#55163
chris mabbott
Participant
  • Topics Started: 119
  • Total Posts: 1525

First remove the pulley which is held into place with a simple grub screw, then I’ll use a fine 1000 grit emery cloth to clean up the shafts before removing the other parts, plus a small shot of WD40, this is where this stuff comes in useful.

Here I’ve removed what I thought were bearing dust covers, held in place by three screws. You can see what I think is a fairly new felt … dust cover? I haven’t seen anything like this previously.

chris mabbottReply To: Motor Rebuild