Reply To: Graham escapement

Home Forums General Discussion Forum Graham escapement Reply To: Graham escapement

#55085
gerene
Participant
  • Topics Started: 16
  • Total Posts: 377

Just realised that I addressed the last paragraph of my previous post to Randy where I meant David 😳 . Don’t know how I did this, probably too occupied with what I am doing rather than paying attention to what I am writing. I appologize to both David and Randy.

Here is a picture of the setup in my Taig lathe. The pallets are now grinded, I will polish them and try to install with correct lock and drop.

Jan

gereneReply To: Graham escapement