Home › Forums › General Discussion Forum › Mclark3617 new member › Reply To: Mclark3617 new member
February 5, 2014 at 6:57 pm
#54874
Well i just bought a K&D staking set from Uncle Larrys, thnks for the tip Randy. Got my screw drivers, balancing calipers,( deal on ebay) and hand remover and watched videos 1 and 2. And i still havent turned a screw. I think its time to slow down, watch some more videos lessons and start tearing into a watch. Im still not sure what kind of lathe i want, i mainly looking to make or modify balance staffs. But i will look into that farther after watching the lathe videos. Thanks for the greetings and advice.