Reply To: One room tool house…Tmac1956

Home Forums Member Shop Pics. One room tool house…Tmac1956 Reply To: One room tool house…Tmac1956

#54456
tmac1956
Participant
  • Topics Started: 171
  • Total Posts: 1259

@david pierce wrote:

Tom,
That green book sitting sideways on your shelf is one of the best refrence sources ever. Turn to the section called STEELS and read through it. I bought my copy in 1978 and still refer to it often. There is so much information there for the machinist: speeds, feeds, materials, cutter angles, thread information, bolt sizes, fit specfications etc., etc, etc. If there was only one book I could buy for machinest work, that would be the book. I always keep a copy by my toilet. That is where I have my best quality study time.
david

David:

I’ll do that. I bought it because I read you commenting on the importance of it. Additionally, we had something similar that we used for just about everything in steel design for structural engineers. I believe it was called the ASIC manual.

Thanks!
Tom

tmac1956Reply To: One room tool house…Tmac1956