Home › Forums › General Discussion Forum › Single Point Threading › Reply To: Single Point Threading
November 11, 2013 at 1:52 pm
#54325
That’s the lathe I had told you about in a phone conversation a while back. I had replaced this lathe with the ROMI for the company in Santa Barbara when I retooled their shop. If I removed it then it was mine to keep! They just wanted it out of there. Two trips in a small Toyota pickup did the trick but it wasn’t easy. It’s about as large as I would want to go without moving up to 3 phase. Ideal for small shop or big garage though. It was only used a few times so like new.
Bob