Reply To: New Mill

[tmac1956]

david:

I have a set on 1/4″ square cutters that I bought from A2Z. I have a few 3/16″ square tools that came with my 3-way, but the set screws in the tool holder aren’t long enough to hold them, so I wind up having to put a shim under them, so I’m back to being a little high with them as well. I can’t set up any kind of under-cut the way it is now. Also, it’s an old metric cross slide and I have no way to zero it out, but it’s ok other than that. It’s a German made slide.

The 3-way is setting hard onto the ways without any kind of shoe.

Thanks!
Tom