Reply To: Milling circles and radi…

Home Forums General Discussion Forum Milling circles and radi… Reply To: Milling circles and radi…

#53950
david pierce
Participant
  • Topics Started: 90
  • Total Posts: 1360

Tom,
When you buy a rotary table make sure it is one that uses dividing plates and sector arms. Also, you will want one that works in both the horizontal and vertical positions. This will allow you to cut gears and pinions on your mill. I think I gave you some information on that before but if you can’t find it I will try to dig it up. Did you get your mill?
david

david pierceReply To: Milling circles and radi…