Reply To: Question about A2Z Quick Change Tool Post…

[tmac1956]

david:

Since the bolt of the QC is slightly wider than the vertical slot on my 3-way slide, my thoughts are as follows:

1) cut down the threaded section on the bolt needed to thread into the T-section for the slot and rethread it again.
2) make another T-section with a neck that fits the vertical slot int the 3-way and drill a hole in the neck threaded to accept the new portion of the bolt.

I think buying those parts from A2Z is wasted money because if the bolt is too fat, then the neck on the T-section is going to be even fatter.

Any thoughts?

Thanks!
tmac