Reply To: Question about A2Z Quick Change Tool Post…

Home Forums General Discussion Forum Question about A2Z Quick Change Tool Post… Reply To: Question about A2Z Quick Change Tool Post…

#53378
tmac1956
Participant
  • Topics Started: 171
  • Total Posts: 1259

@david pierce wrote:

Tmac,
The one that came with my quick change was too large and I brought it down to size with my Taig lathe and a file. The entire job could have been done with a file only or a belt sander or whatever tools are available. As long as it fits into the slot and holds the tool post that is all that is required of it.
david

Well… I have a good vise, a good set of files, a Dremel, and a vernier caliper. With eight peices to the pack, I think I can modify one that will work. ;) I’ll go back to your original post and follow those steps.

Thanks!
tmac

tmac1956Reply To: Question about A2Z Quick Change Tool Post…