Home › Forums › General Discussion Forum › Taig Made in USA › Reply To: Taig Made in USA
David,
I didn’t see you posted this here. I have been in the process of moving, so I have not bought the lathe yet. I am going to order it within the next week probably.
I posted this ins the “How to Tell the Spouse” section. I was pricing everything, and came across these products, and wanted to know your opinion on them. Here is what I posted:
—
David,
Thank you again for all of your help. I have put together a list of what I think I need. It is a little out of my budget, though. I budgeted about $600-$650, and this is up to $767.53 after shipping of all items. Here are the links to each item I think I need to get me started strong.
Can you please confirm or deny either of the products here?
Thank you again for your expertise. You are a lifesaver.
The lathe with the drilling tailstock, motor, pulleys, everything to get basically started
http://www.ebay.com/itm/150998963658?ss … 1438.l2649
Carbide bits for pivots. I had a hard time finding these. These were the only ones I could find that looked like what I needed.
http://www.ebay.com/itm/310583954759?ss … 1438.l2649
Metric ER-16 Collets. From 0.5mm, 1mm, 2mm all the way to 9mm
http://www.ebay.com/itm/150959210668?ss … 1438.l2649
Imperial ER-16 collets, from 1/32″ to 3/8″. I did the metric conversion for these, and most of them fall near enough to the #.5mm of the metric collets.
http://www.ebay.com/itm/330733443318?ss … 1438.l2649
Taig 1190 Steady Rest, for pivot support
http://www.ebay.com/itm/190804036306?ss … 1438.l2649
Taig Tool Rest, for doing pivots with the Steady Rest.
http://www.ebay.com/itm/321068270885?ss … 1438.l2649
ER-16 Headstock
http://www.ebay.com/itm/221171162161?ss … 1438.l2649
—-