Reply To: Re-pivot tiny pivot HHEELLPP!!

Home › Forums › General Discussion Forum › Re-pivot tiny pivot HHEELLPP!! › Reply To: Re-pivot tiny pivot HHEELLPP!!

February 6, 2013 at 9:02 am #52863
david pierce
Participant

    Digital Tripper,
    I sucessfully drilled two #80 holes 1/4 inch deep into a piece of cold rolled bar stock. That is the good news. The bad news is I drilled the holes with a Dumore Sensative Drill Press with an Albrecht 15-J0 keyless drill chuck. This weekend I will have a little more time and will try and find a less expensive solution for you.
    david