Home Forums General Discussion Forum Lathe collets… Reply To: Lathe collets…

#52763
tmac1956
Participant

    @david pierce wrote:

    Tmac.
    One thing you may want to add later is a quick change tool post. It is a tiny version of the ALORIS quick change design. I bought mine for under $100.00 off of Ebay from a place in Oakland California. I will try to find out who I bought it from and get back later on this. It isn’t absolutly necessary but it is extremely convenient because your tools are pre-aligned and are slipped in and out with a cam lock. It takes up a little more vertical room so if you think you might want to go that route, the two way crosslide takes up a little less vertical space.
    david

    David:

    That would be great. I appreciate any advise you can give.

    Thanks!
    tmac