Reply To: Newbe advice on a lathe…

Home Forums General Discussion Forum Newbe advice on a lathe… Reply To: Newbe advice on a lathe…

#52603
david pierce
Participant
  • Topics Started: 90
  • Total Posts: 1360

Alan,
Let me know when you are ready to reassemble the headstock. You need to pick up a 3/16ths diameter O-Ring that is the same diameter as the existing belt. It will power the lathe much better than the heat together type of belt. Keep me informed.
david

david pierceReply To: Newbe advice on a lathe…