Reply To: Newbe advice on a lathe…

Home Forums General Discussion Forum Newbe advice on a lathe… Reply To: Newbe advice on a lathe…

#52589
david pierce
Participant
  • Topics Started: 90
  • Total Posts: 1360

Alan,
You will not have to buy a new headstock. You can get the stuck part out of the spindle. You will have to get a brass rod of the proper size and disassemble the headstock as I posted in the last thread. You want to remove the part without damaging the spindle. This can be done with the proper procedures.
david

david pierceReply To: Newbe advice on a lathe…