Home › Forums › General Discussion Forum › Jacot Tool › Reply To: Jacot Tool
July 6, 2012 at 2:16 pm
#52002
Hi Paul,
Yes it’s used for burnishing pivots.
There is a good video out there already which would be hard improve on by Ron DeCorte. I’ll find a link asap and will put it up here for you. We touched on this a tiny bit in a previous thread back in 2010 located here http://www.clockrepairtips.com/forum/viewtopic.php?f=2&t=111 if you want to take a look.
I’ll grab a link to the DVD.
Ok, I’m back…it can be purchased up on eBay by clicking the following link and if the link expires then just put Jacot lathe Ron DeCorte into ebay search. Here it is: http://www.ebay.co.uk/itm/NEW-Jacot-Lathe-Video-DVD-VDO-108-/290331512976
Anything Ron DeCorte puts out is good.
Enjoy!
Bob