Home › Forums › General Discussion Forum › New Mainspring › Reply To: New Mainspring
May 24, 2012 at 8:02 am
#51644
That’s the hole I’m talking about. It is for the t-end of the mainspring to go into. It is located on the outside edge of the mainspring barrell. Perhaps I’m making the mistake of winding the entire spring into the winder and then trying to set it correctly into that t-end hole. It doesn’t look like there is any rap that would allow the t-end to pop out. I think that when it expends from the winder in the barrell it’s just expanding past the hole. Is there anyway to readjust the spring once it’s been loaded into the barrell or do I have to take it out and start again?