Reply To: Help with pivoting going wrong!

Home › Forums › General Discussion Forum › Help with pivoting going wrong! › Reply To: Help with pivoting going wrong!

July 6, 2011 at 11:28 pm #50744
pkamargo
Participant

    Hi Bob,

    Since an EDM machine is not avaiable and I don’t have a diamond drill of this size too, I guess that the broken carbide drill will stay there forever….

    The construction you suggested is a nice solution and would be the only choice if the broken drill was occupying all the hole.
    However before going to this I will first try to use the reduced depht hole to install the pivot. Hope I can fit it tight enough.

    Thank you for all the suggestions.