Home › Forums › General Discussion Forum › Ingraham Clock Repair › Reply To: Ingraham Clock Repair
February 13, 2011 at 2:54 pm #50523
Well here is another and more pressing issue. The clock requires a couple bushings. The bushing for the escapement wheel pictured is badly worn. Someone had installed a bushing and peened it into place. The pivot is best sized at 1.25mm. The old bushing outside diameter appears to be close to 4.5mm. Bergeon doesn’t make bushings with this small a pivot hole and such a large outside diameter. Any suggestions?
Also the escapement wheel is on a riveted on arm. Sure doesn’t want to clamp into the Bergeon bushing machine. Any suggestions here would be greatly appreciated.
- This reply was modified 1 year ago by Tamas Richard.